Nord One NC500MB - Mono Block Black Single

 

NC500MB Amplifier in Mono Block case with Hypex NCore NC500 delivering power for the most demanding speakers with ultimate bass control and sound.  Musical, dynamic, warm, and engaging with a soundstage you could wade through.

Italian all aluminum case complete with 10mm faceplate, solid 44mm diameter aluminum isolation feet. Patented CHK Binding Posts, gold plated solid brass 60A binding posts, Switchcraft gold plated metal body XLR socket, Quality mains sockets and blue "Halo" illuminated front switch.

So we take a mix of standard products add bespoke touches and use high quality European and USA components, sell them direct to you missing out the middle men, offering you a high quality product at sensible prices.

 

• Black Finish Mono Block Case

• Hypex NCore NC500 Module

• Hypex SMPS1200A700 Power Supply

• Nord (cut down) REV C Buffer Board with OPA1612 Daul Op Amp

• Mono Block Design

• Distortion: THD+N - - 0.001 % 20Hz

• Frequency Response: 0 - 50k Hz +0/-3dB

• Low Distortion: THD+N - - 0.001 % 20Hz

• High Input Impedance 47K

• 26 dB Gain

• Ultra High Damping Factor

• High Current Output Capable of driving 2ohm for the

   Most Demanding of Speakers.

   550W 2ohm

   700W 4ohm

   400W 8ohm

• Frequency Response: 0 - 50k Hz +0/-3dB

• Case W 240mm D 280mm H 90mm

   With Feet and Binding Posts W240mm D340mm H95mm

• Weight 4.2\Kg each 

 

 

Hypex NCore

Our Amplifiers are powered by Hypex NCore modules. Simply put Audiophile consensus of opinion agrees these are the current best Class D modules available.

 

93% Efficiency

Whilst you should not choose an amplifier for its efficiency alone our amps are around 90% efficient at full volume. Idle power consumption is 18W compared to 150-200W for a Class A/B power amplifier. Low cost to run and wont heat your room in the summer. If you choose the 12V trigger option to power the amps on remotely from a Pre Amp the standby consumption is 0W

 

Aluminium Case

We use the same family of quality Aluminium cases throughout our range with fully vented top cover. Made in Italy with 10mm anodized front panels which we CNC mill to reveal contrasting Aluminium. They sit on stylish solid 44mm dia Aluminium isolation feet.